Machined Aluminum Mosfet Regulator fits BMW C 600 650 GT Sport 2011 2012-2017

Description

Free
shipping in USA
Same day
shipping
visit our store >
find parts for :
ATV / UTV / SXS
Motorcycles
Snowmobiles
Watercraft
Other
Menu
Store Home
find parts for
ATV / UTV / SXS
Motorcycles
Snowmobiles
Watercraft
Other
Machined Aluminum Mosfet Regulator for BMW C 600 Sport | C 650 GT / Sport 2011-2017 | OEM # 12317718422
Battery condition is extremely important. No voltage regulator can work correctly with a bad or weak battery.
Always fully charge your battery before performing any charging system tests or replacing parts.
If there is any doubt, have the battery load tested or replaced.
Please note:
that there are multiple regulator possible for Triumph Street Triple, Speed Triple and Bonneville. Below you will find a list of what our part fits on and in bracket our part if it's available or the replacement OEM you will need if it does not fit the requirements:
Street Triple
with a VIN
higher
than 560476 and an engine number
lower
than 354281 or
higher
than 456777 (RM30104 or T1300570)
Street Triple R
with a VIN
lower
than 560476 and an engine number
higher
than 456777 (RM30104)
Street Triple Standard
with a VIN
lower
than 560476 and an engine number
higher
than 456777 (RM30104 or T1300570)
Street Triple Standard
with a VIN
higher
than 560477 and no engine restriction
Street Triple RS
with a VIN
between
800262 et 965682 and
lower
than 966534 and no engine restriction
Speed Triple
with a VIN
between
461332 and 735437 and an engine number
higher
than 499957 (T1300165 or T1301564)
Bonneville
with an engine number
higher
than 456777 (RM30405)
Other Triumph models in the fitments list below that are not mentionned before are a direct fit and do not have any restrictions. Please always compare your original part to our photos to make sure you are purchasing the right part.
Brand new RMSTATOR Red Machined Aluminum Mosfet Regulator
Our new red machined aluminum Mosfet voltage regulator is a great upgrade for heat dissipation in any powersports charging system. After 10 minutes of use, our billet aluminum heatsink runs cooler by 33% than standard cast regulator housings. Our new red regulator, equipped with the renowned Mosfet regulation technology, is an added value to any three-phase permanent magnet charging system.
STOP BURNING YOUR REGULATOR RECTIFIER !
It is time to update or replace your voltage regulator with the advanced MOSFET type.
It runs cooler than all OEM diode style regulators. In addition, this rectifier has overheat protection, rather than burn up, it will simply turn off for a while and cool off.
Direct replacement to your original unit
Plug-and-play, direct fit, easy installation
The quality exceeds the OEM equipment
Improved heat sink and charging capabilities
Higher grade of electric components
All shipped products are tested
We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause of repetitive electrical issues.
*All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.
Why use Mosfet Enhanced technology?
Runs cooler
Runs much cooler than the traditional Shunt voltage regulator rectifier.
Saves gas
Less load on the stator, less work, less fuel is used and you save.
Regulated energy
The power charging your battery is steadier and smooth.
Extended battery life
Extends the battery’s life and cold cranking capacity.
More engine power
Removes stator load resulting in more engine power.
Optimized power
Optimize power delivery by switching the stator coils on or off.
With
design
This product is an advanced design that lowers operating temperatures for extended longevity and better performance than the OEM part.
Vehicle models fitment
BMW C 600 Sport -- 2013-2015
BMW C 650 GT -- 2013-2020
BMW C 650 Sport -- 2016-2020
OEM part replacement
31600-MGZ-J01
21066-0008
1D7-81960-00-00
278002021
32800-26J01
0824-078
21066-0022
21066-0714
21066-0744
0800-177000
27D-81960-00-00
31600-HP0-A01
31600-HR0-F01
31600-MJF-A01
5JW-81960-00-00
710000261
T1300470
T1300675
8JP-H1960-00-00
31600-HN8-003
0000516
21066-0771
31600-HN8-000
32800-26J00
54040301B
710000870
710001103
1D7-81960-01-00
0824-072
12317718422
12318523367
4012941
515177325
710000908
710005569
32800-26J02
Specifications
Dimensions:
Width: 103 mm
Length: 103 mm
Height: 28 mm
Fixation holes center to center: 80 mm
Other specifications:
Number of plugs: 2
Number of pins: 5
Number of wires: 0
Minimum Charging Voltage: 14.5 V +- 0.5 V
Maximum Charging Current: 50 A / 500 W
Open Circuit Voltage: 15 V
Operation Temperature: -20?C to 85?C
instructions
Before installing your new CNC Voltage Regulator Rectifier:
Check the AC output of the stator.
Replace any burned or corroded connectors on stator and regulator rectifier.
Check and repair any melted wiring.
Use hi-temp dielectric grease on all connectors.
SHIPPING
We deliver 99.4% of our orders within the specified time period. If your item is not available in our main Colorado facility, we still guarantee that your order will be delivered within the specified time period.
If your item is not delivered within this time period, we will offer you a 5.00$ discount on your order. This guarantee applies to shipments delivered in the 48 continental USA states, excluding PO boxes.
Videos
customer service
AsK seller a question
duties & taxes
International Buyers:
Import duties, taxes, and charges are not included in the item price
or shipping cost. These charges are the buyer's responsibility.
RaceTech Electric was founded in 2011 by three motorcycle industry veterans in San Diego, CA. The group has over 20 years combined in the Motorcycle industry.
Customer service
Part request
About us
About seller page
Add seller to favorite